BRUEL & KJAER VIBROCONTROL 8000 - Software omenclature Visualizing VC-8000 Data; Viewing the Maintenance Display

Page 82 of 188
█ © Brüel & Kjaer Vibro ● S1079330.002 / V04
Technical alterations reserved
EN
12 Software - Visualizing VC-8000 Data
VC-8000 data is typically visualized as follows:
• VC-8000 local display on touch screen panel (optional)
• VC-8000 Maintenance software (laptop computer)
• Multimeter connected at the rack.
• DCS screens (via Modbus, or Analog 4-20 mA)
• SETPOINT CMS software
This section focuses on viewing VC-8000 data using the Local Display panel, the maintenance
software, or using a multi-meter connected directly to the rack.
12.1 Viewing the Maintenance Display
The VC-8000 Touch Screen display and the VC-8000 Maintenance software display are essentially
the same - with a few exceptions; for example, the touchscreen cannot be used to bypass channels,
view licensing, or perform firmware upgrades.
The display has the following tabs
• Rack
• Machine
• System Events
• Alarm Events
The colors used on the displays indicate the following:
Color Activity Description
Green
Solid
Channel is OK
Flashing
Unacknowledged fault or alarm event
Red
Solid
Channel in Danger
Flashing
Unacknowledged Danger event
Yellow
Solid
Channel in Alert
Flashing
Unacknowledged Alert event
Gray
Solid
Channel is in Fault
Flashing
Unacknowledged Fault event
Table 12-1) Filtering the grid, examples