BRUEL & KJAER VIBROCONTROL 8000 - 12.1.8 Event Lists; 12.1.9 Firmware and Hardware Info; 12.2 Configuring the VC-8000 Displays

Page 88 of 188
█ © Brüel & Kjaer Vibro ● S1079330.002 / V04
Technical alterations reserved
EN
12.1.8 Event Lists
View the event lists (Alarm or System) by selecting the appropriate tab. The event lists can be sorted
by clicking on the column header.
A laptop running Maintenance software should be used to view the event lists. The event list can be
multi-sorted by holding the SHIFT key while clicking the second column header etc. Also, the event
list can be copied to a spreadsheet by clicking in the top left corner (select all) and then copy and
paste.
Figure 12-6) Event list
12.1.9 Firmware and Hardware Info
Firmware and Hardware information tabs are not available on the touchscreen display. They can only
be viewed when connected to the rack with VC-8000 Maintenance software.
See Firmware and Hardware Info in section 23Troubleshooting (Maintenance).
12.2 Configuring the VC-8000 Displays
There are several text fields and grouping options used to customize the VC-8000 Maintenance
software, and Touch Screen Display. They are:
Parameter Location
Module Description
Modules tab, All view
Channel Name
Channels tab, Summary view
Asset Level 1
Channels tab, Summary view
Asset Level 2
Channels tab, Summary view
Channel Display Order
Channels tab, Summary view
Asset Level 1 Order
Asset Display Order tab, All view
Asset Level 2 Order
Asset Display Order tab, All view
Table 12-3) Configuring the Maintenance displays