Page 28 of 188
█ © Brüel & Kjaer Vibro ● S1079330.002 / V04
Technical alterations reserved
EN
3.2 Bulkhead Mounting
Bulkhead mounting takes full advantage of the VC-8000 rack design. The rack is compact and light.
All modules are easily accessible.
The bulkhead mount rack, has flush mount brackets installed on the backside of the rack as shown.
The mounting-hole pattern for bulkhead mounting is the same as for panel mounting. For mounting
hole drawings please go to the downloads section on the B&K Vibro website.
Figure 3-1) Bulkhead Mounted, no faceplate, no display
Be sure to use a wiring harness to keep signal cables from blocking the airflow through the rack.
Airflow is needed for cooling.
A bulkhead mounted rack with a door mounted on the front of the rack, is not recommended. This
allows more room for signal cables etc. A door on a 16P rack is very long; when it is opened it creates
a hazard for persons working in the cabinet.
A bulkhead mounted rack with a door mounted display is not recommended. Use a remote display
panel instead. This allows more room for the signal cables etc.
To Next Page
Loading...