BRUEL & KJAER VIBROCONTROL 8000 - Configure Remote Connection

© Brüel & Kjaer Vibro ● S1079330.002 / V04 ● █ Page 79 of 188
Technical alterations reserved!
Brüel & Kjaer Vibro │ Instruction
VC-8000 MPS
Content
EN
Authority User Authority User
Maintenance Software
Connect X
X
X
Save a VC-8000 Maintenance file
X
X
X
View display screens, event lists, etc.
X
X
X
Acknowledge alarms
X
X
X
Bypass signal channels or relays
--
X
X (PW)
Update Firmware
--
X
X (PW)
Upgrade Licenses
--
X
X
Password reset file (forgot password)
--
--
X
Set rack time
--
X
X
Request a set of Boost mode waveforms
X
X
X
Reboot SAM (CMS) port
--
X
X (PW)
Setup Software
Connect X
X
X
Set and enable initial passwords
--
--
X (PW)
Change User (View Only) Password
--
X
X (PW)
Change Administrator Password
--
X
X (PW)
Get (upload) configuration
X
X
X
Save configuration file
X
X
X
Send configuration
---
X
X (PW)
Table 11-1) Remote access account privileges
PW: Requesting this action will Initiate the administrative logon screen. This is only applicable for
local (USB) connections when the Administrator password is set.
11.6 Configure Remote Connection
Remote access to the rack is provided through the CMS Ethernet port. Remote access can be given
to the User (View Only) account, the Administrator account, or both. If the account has a password
set, and remote access is enabled, remote access will be granted. A local (USB) connection is
required to enable remote access and set the initial passwords.
To enable remote access:
• Verify that the rack includes an ‘MPS Remote’ license
• Set the account password.
• Enable MPS Remote Access in the SAM configuration settings
• Configure the CMS IP Address in the SAM configuration settings.
Again, this initial setup must be done locally using a USB connection. After the password is set
locally, it can be changed remotely using the Administrator account. If the password is disabled (set to
blank), remote access for that account will also be disabled.