BRUEL & KJAER VIBROCONTROL 8000 - Configuring - CMS Data Collection; Managing Data Collection

Page 96 of 188
█ © Brüel & Kjaer Vibro ● S1079330.002 / V04
Technical alterations reserved
EN
13 Configuring - CMS Data Collection
13.1 Data Types
The SETPOINT CMS system collects a full suite of data types to increase your ability to diagnose
machinery problems (see Table 13-1).
Data Type Examples
Static
Radial Vibration (Direct) Gap, Axial (Direct), Seismic (Direct)
Vector Data
1X Amplitude, 1X Phase
Waveforms
Synchronous, Asynchronous (also Peak Stretch)
Status
Alarm, Faults, Quality etc. for each measurement and waveform.
Table 13-1) CMS Data Types
13.2 Managing Data Collection
CMS data collection and data storage configuration settings are found in several locations in the VC-
8000 Setup software configuration. These settings are shown in the table below.
CMS Setting Location
VC-8000 CMS licensing
Maintenance software
Hardware Info Tab
Enable CMS data collection, Rack Name, IP Address etc.
Setup software
Modules Tab
SAM Settings
CMS Navigation Path, Waveform collection triggers,
Startup/Shutdown window definition, etc.
Setup software
Channels Tab
CMS Framework View
Asynchronous and Synchronous waveform settings
Setup software
Measurements Tab
Waveform View
Table 13-2) CMS data collection settings
13.2.1 SETPOINT CMS Licensing & Firmware Revisions
VC-8000 SAM, UMM & TMM modules must be licensed for CMS data collection. To view the
licenses, connect to the rack using VC-8000 Maintenance software (see section 23.10). To purchase
a CMS license please contact your local B&K Vibro representative.
UMM/TMM modules require firmware revision 3.0 or higher as shown in the table below.
Module
Firmware Revision Required
UMM
3.0 or higher
TMM
3.0 or higher
Table 13-3) UMM/TMM CMS compatible firmware