BRUEL & KJAER VIBROCONTROL 8000 - CMS (SAM) Connection Settings; 13.2.2.1 CMS Rack Name; 13.2.3 CMS Navigation Path

© Brüel & Kjaer Vibro ● S1079330.002 / V04 ● █ Page 97 of 188
Technical alterations reserved!
Brüel & Kjaer Vibro │ Instruction
VC-8000 MPS
Content
EN
The SAM (CMS) firmware must be version 3.0 or higher as shown in the table below.
CMS Function CMS (SAM) Firmware Revision Required
CMS PI
3.0 or higher
CMS SD
4.02 or higher
CMS HD
5.0 or higher
CMS XC
3.0 or higher
Table 13-4) SAM Firmware revision for CMS functions
13.2.2 CMS (SAM) Connection Settings
This CMS Ethernet port provides the network connection
for the CMS PI/XC Adapter software. The port is
configured in the SAM settings.
The following settings must be configured for CMS data
collection:
• CMS Enabled
• CMS Rack Name
• CMS IP Address
• CMS Subnet mask
13.2.2.1 CMS Rack Name
A unique rack name is required. If you are using OSI Soft PI for CMS data collection, this name will
be used as a prefix to the PI tags.
13.2.3 CMS Navigation Path
The CMS Navigation path is used to build the navigation structure in the CMS software. A CMS
Navigation path is required only for CMS enabled systems.
Figure 13-2) CMS Navigation Path
Notice in Figure 13-2 that U3 and U5 have an asterisk next to them. The asterisk (*) is not visible in
the CMS software. An asterisk is mandatory and is used to designate the component (in the path) that
represents the machine train.
Figure
13-1) CMS Connection Settings