© Brüel & Kjaer Vibro ● S1079330.002 / V04 ● █ Page 69 of 188
Technical alterations reserved!
Brüel & Kjaer Vibro │ Instruction
VC-8000 MPS
Content
EN
10 Software – Introduction (Start Here)
10.1 Software Installation
Download the latest software from the Brüel & Kjær Vibro website. You must have Administrator
privileges on your computer to install the software. To install the software:
• Double Click on MPS_Setup.exe.
• Follow the instructions to complete installation.
Three applications will be installed.
Icon Software Description
Rack Setup
Contains spreadsheet type views used to
configure the full rack, modules, channels,
measurements, limits and relay, etc.
Rack Maintenance
Contains several displays (bar graphs, event
lists etc.) to view data and perform maintenance
tasks – such as firmware upgrades.
Simulator Launcher
Used with Rack Maintenance software to
simulate a rack (virtual) and verify the display
layout or other functionality like CMS.
This shortcut may be removed if the user isn’t
involved in maintenance or testing.
Table 10-1) MPS Software
To Next Page
Loading...