BRUEL & KJAER VIBROCONTROL 8000 - 10.2 Rack Setup - Software Navigation

Page 70 of 188
█ © Brüel & Kjaer Vibro ● S1079330.002 / V04
Technical alterations reserved
EN
10.2 Rack Setup - Software Navigation
The Rack Setup software is a spreadsheet type application. The configuration parameters are viewed
in rows and columns. Copying and pasting between cells, sorting columns, and filtering are available.
There are five main areas used for navigation and setting properties.
Figure 10-1) Software Navigation Features
Control Description
(1) Tab Selection
Select major categories
(2) View Selection
Select sub-categories
(3) Filter
Filters on all columns marked with an asterisk
(4) Properties Window
Show all properties for the selected row
(5) Grid
Edit properties in the main configuration grid
Table 10-2) Software Navigation Description
In a typical configuration of a VC-8000 rack the user will start with the Modules tab, then proceed to
the Channels tab etc. At each tab, the user will progress through each View, before moving on to the
next tab.
Note: Always start by setting Module Type, and Channel Type settings first. If you change the
Module, or Channel type, the channel properties will return to default values.