BRUEL & KJAER VIBROCONTROL 8000 - Page 84

Page 84 of 188
█ © Brüel & Kjaer Vibro ● S1079330.002 / V04
Technical alterations reserved
EN
RCM and SAM functions and their respective indicators on the Rack View display are described in the
table below.
Indicator Color Description
OK
Green
OK relay normal (all channels are in OK)
Gray
OK relay tripped (channel(s) in a fault condition)
Multiply
Green
Trip Multiply Active
Gray
Trip Multiply Off
Inhibit
Green
Inhibit Active
Gray
Inhibit Off
Special Inh
Green
Special Alarm Inhibit Active
Gray
Special Alarm Inhibit Off
P1, P2
Green
Power On (and in valid range)
Gray
Power Off
Modbus
Green
Modbus enabled with active communication occurring
Yellow
No incoming requests for data (no communication)
Gray
Modbus not enabled (Off)
SD or
SD Busy
Green
SD card installed and functioning
Green (SD Busy)
SAM writing to the SD card
Yellow
SD is enabled, but the SAM cannot write to the card
(Not shown)
SD not enabled (off)
HD or
HD Full
Green
HD is On
Green (HD Full)
HD is full. New data is overwriting the oldest data
Yellow
HD write failure
(Not shown)
HD not enabled (off)
CMS
Green
CMS OK
Yellow
CMS Not Ok (Adapter not communicating)
(Not shown)
CMS is not enabled (off)
Table 12-2) RCM and SAM functions (indicators)