MAX Operation & Service Manual 105MAX Operation & Service Manual Section 6: Maintenance & Service 105
Replacing the Duster Cloth
Parts needed: new duster cloth supply roll
1. With the machine on the approach and in the Transport Position, open the covers.
2. Grasp the supply roll side located nearest to the mid-frame wall and rotate by turning counter-
clockwise (from 7-pin side).
3. Slide the waste roll to the 7-pin side, and remove from the machine
4. Tip the duster cloth take-up roll to allow the metal stiffener tube to slide out of the duster cloth
take-up roll core. Set the metal stiffener tube aside and dispose of the duster cloth take-up roll
and core.
5. Remove the empty duster cloth supply roll core from the top position by following the same
process as in 2 & 3 above. Keep the metal stiffener tube with the empty duster cloth supply roll
core.
6. Insert the metal stiffener tube from the duster cloth take-up roll core into the new supply roll
core and install the new duster cloth supply roll in the upper supply roll position on the machine.
7. Unwind several feet of cloth and route it through the duster system as shown on the routing
decal. This decal should be located on the left side wall of the machine (7 pin side) in the area of
the supply roll hub.
8. Drape the loose end of the duster supply cloth over the top of the waste recovery tank and onto
the electronics enclosure.
9. Remove the paper backing from the unused strip of double sided tape on the old duster cloth
supply core.
10. Lay the core, adhesive side down, across the duster supply cloth between the waste recovery
tank and the electronics enclosure. Care should be taken to keep the core at a straight 90 degree
angle to the cloth.
11. Wind the duster cloth over the top of the old duster cloth supply core as shown on the routing
decal.
12. With at least two full winds on the old duster cloth supply core, install it into the lower, duster
cloth take-up roll position in the front of the machine.
13. From the Maintenance Diagnostics for the cleaning, wind up the excess cloth using the “Duster
Cloth: Wind” button. Repeat until the Duster Up switch highlights.
14. Reset the Duster Cloth counter in the Maintenance Counters screen.
15. Close the covers and resume operation of the machine.
To Next Page
Loading...
