Brunswick MAX - Page 113

MAX Operation & Service Manual 113MAX Operation & Service Manual Section 6: Maintenance & Service 113
7. Adjust the guides.
a. Moving the guides towards the front of the machine forces more pressure on the center of
the squeegee blade (for lane depressions).
b. Moving the guide blocks towards the rear of the machine releases pressure from the center
of the squeegee blade (for crowning lanes) and applies more pressure to the absorbent
wiper.
8. Tighten the bolts for the squeegee adjustment guide blocks. Verify the squeegee has some play
to pivot forward and backward and is not binding in the guide blocks.
9. Place the machine on the lane surface.
10. Visually check the squeegee for even deection away from the vacuum head.
NOTE:Itmaybenecessarytoperformthesqueegeeheightadjustmentaftermakingthepitch
  adjustment.
11. Replace the waste tank.
12. Restore power to the machine and test clean the lane.