112 MAX Operation & Service Manual112 Section 6: Maintenance & Service MAX Operation & Service Manual
Adjusting the Squeegee Blade Pitch
Tools needed: 3/8” open-end wrench, 7/16” open-end wrench.
Refer to Figure 6 -13
Adjustment: slightly forward from center of the adjustment slot.
.
(1)
(3)
(1)
Figure6-13.AdjustingSqueegeeBladePitch
(1) SQUEEGEE ADJUSTMENT GUIDE
BLOCKS
(2) ABSORBENT WIPER (3) SQUEEGEE BLADE
1. Place machine in Operating Position with the covers open and the power supply on.
2. Go to the “Cleaning Diagnostics” screen in the “Maintenance” menu of the Tablet.
3. Lower the squeegee head so the sensor shows the squeegee is down and remove the waste
recovery tank.
4. Place the machine on the lane and push the machine out to the arrows.
5. Raise the machine into the transport position.
6. Loosen, but do not remove, the two mounting bolts for each the squeegee adjustment guide
blocks on the 7 and 10-pin sides.
To Next Page
Loading...
