Brunswick MAX - Page 126

126 MAX Operation & Service Manual126 Section 6: Maintenance & Service MAX Operation & Service Manual
Installing the Oil Pump and Filter Assembly
1. Re-install the “Conditioner Pump and Filter” assembly back into the machine and fasten the 3
screws for the center wall.
2. Fasten the bracket to the drip pan.
3. Connect the tubes on both sides of the “Oil Pressure” valve, the oil supply tube at the pre-pump
lter, and from the outlet side of the spin-on lter.
4. Connect the “Oil Pressure” valve and “Oil Pump” cable assemblies.
Removing the Conditioner Pump
Tools needed: 3/8” open end wrench.
1. Remove the Conditioner Pump and Filter Assembly. Refer to RemovingConditionerPumpand
FilterAssembly procedure.
2. Remove the pre-pump lter assembly from its holders and pivot up.
3. Using the 3/8” wrench to remove the 4 mounting screws for the pump.
4. Remove the pump from the bracket assembly.
5. Disconnect the tube from the pump that connects to the Spin-on lter.
6. Disconnect the pre-pump lter assembly from the pump.
Installing the New Conditioner Pump
1. Place the pump onto the 4 mounting screws on the bracket.
2. Fasten the 4 washers and 4 nuts to the mounting screws.
3. Tighten the 4 nuts until 4-5 threads extend above the nuts.
Removing and Installing the Oil Pressure Valve
Tools needed: 3/32” Allen wrench
1. Using the Allen wrench, remove the 2 mounting screws for the oil pressure valve.
2. Fasten the new oil pressure valve using the screws in the previous step.
Bleeding the Conditioner System and Checking for Leaks
1. Fill the conditioner tank and turn on the Temperature Cycle function and check tubing for leaks.
2. In the Operator screen, turn on the Temperature Cycle Override. Air will be purged from the
system during the process.
3. Check the tubing for the Oil Pump and Filter assembly for leaks.