140 MAX Operation & Service Manual140 Section 6: Maintenance & Service MAX Operation & Service Manual
4. Disconnect sensor cable from the quick-connect cable harness.
5. Pull sensor out from the top side of the machine and remove the second O-ring on top side of
the sensor.
6. Place an O-ring under the top-side nut and then install new sensor from top side of the machine.
7. Place the second O-ring on the sensor pushing it up to the bottom side of the mounting shield.
8. Insert and tighten nuts at base of sensor until the end of the sensor is just even with the bottom
edge of the lower nut.
NOTE:DONOTovertightennuts.
To Next Page
Loading...
