Brunswick MAX - Page 141

MAX Operation & Service Manual 141MAX Operation & Service Manual Section 6: Maintenance & Service 141
Adjusting the Distance Encoders
Tools needed: 11/16” wrench, 3/8” socket wrench, feeler gauges.
Refer to
Figure6-25.
Figure6-25.DistanceEncoders
(1) DISTANCE ENCODER
(4) FRONT ENCODER WHEEL SPROCKET
(2) MOUNTING BRACKET (3) REAR ENCODER WHEEL SPROCKET
NOTE:Theremoval,adjustmentandreplacementprocedureisthesameforboththerearand
frontencodersensors.
1. Place machine in transport position with the power supply disconnected.
2. Remove the battery clamps with the 1/8” Allen wrench.
3. Disconnect the battery cable from the electronic enclosure and remove the battery from the
machine.
4. Remove the 4 screws that fasten the battery tray to the rear and center frame using the 1/8”
Allen wrench.