142 MAX Operation & Service Manual142 Section 6: Maintenance & Service MAX Operation & Service Manual
5. Check the distance between the encoder and the encoder wheel sprocket, using the set of
feeler gauges, and verify that it is 1.5 mm +/- 0.5 mm (.06” +/- .02”). To adjust distance, do the
following:
a. Loosen mounting nut on bottom side of mounting bracket using 11/16” wrench.
b. Adjust assembly position so that the sensor end of the distance encoder extends 15/16”
from the bottom side of the encoder bracket
c. Tighten mounting nut to secure position.
d. Check the distance between the encoder and the encoder wheel sprocket, using the set of
feeler gauges, and verify that it is 1.5 mm +/- 0.5 mm (.06” +/- .02”).
To Next Page
Loading...
