148 MAX Operation & Service Manual148 Section 6: Maintenance & Service MAX Operation & Service Manual
6. Using the old switch as a guide, reconnect the wires on the new switch following the order for
wire connections. Refer to electrical schematics in the Appendix for details.
7. Mount the new switch to the bracket using the 2 mounting screws.
8. Insert and tighten the 2 bolts to secure the bracket to the side wall.
9. Check to ensure there is a 1/32” to 1/16” gap between the cord-kill stud and the switch body to
provide the proper contact between the plunger on the lanyard and the switch.
To Next Page
Loading...
