MVX250i E, MVX200i E, MVX200 E
SERVICE MODE · ADJUSTMENT
17
5-2 AF Section Adjustment
Note)
(1) The sections 5-2-1 : CZ automatic adjustment and 5-2-2 : Cam correction (AUTO) must be executed consecutively. If they are
performed independently, the sufficient performance cannot be obtained.
Also, when section 5-2-1 : CZ automatic adjustment is completed, execute section 5-2-2 : Cam correction (AUTO) must be
executed immediately without elapse of time. If execute section 5-2-2 : Cam correction (AUTO) is executed after elapse of time
upon completion of section 5-2-1 : CZ automatic adjustment, the sufficient performance cannot be obtained.
Preparation)
(1) For CZ automatic adjustment/cam correction, set the product condition.
(2) Adjustment condition (initial condition)
Tape/Card : Tape
Program AE : Auto Mode
ZOOM : Telephoto-end
CZ adjustment chart : 2.4 ± 0.02 m from lens front
Chart luminance : 500 lux or more (High illuminance should be avoided at the wide-angle end.)
To Next Page
Loading...
