MVX250i E, MVX200i E, MVX200 E
GENERAL DESCRIPTION OF PRODUCT
77
5-9 Warning displays
COPYRIGHT PROTECTED PLAYBACK IS RESTRICTED
• When copy-protected tape is played.
COPYRIGHT PROTECTED DUBBING RESTRICTED
• When copy protection information is detected during DV input or LINE input, or when the signal output from the television or
VCR is garbled during analog input.
SET THE TIME ZONE, DATE AND TIME
• When the power is turned on without setting the area and/or time and date.
REMOVE THE CASSETTE
• When a cassette is inserted while there is a mechanical error or condensation in the unit.
CHECK THE DV INPUT
• When “REC” is pressed in a mode that allows transition to REC, without a connection to DV input, or in a condition where the
connected DV input cannot be recognized.
CHANGE THE BATTERY PACK
• When the battery power is low.
CONDENSATION HAS BEEN DETECTED
• When condensation is detected (if a cassette is inserted, a “REMOVE THE CASSETTE” message appears).
THE TAPE IS SET FOR ERASURE PREVENTION
• When “REC” is pressed in a mode that allows transition to REC in VCR mode, if the cassette is set for erasure prevention. In
Camera mode, when the power is turned ON, when the “Start/Stop” button is pressed, and when a cassette is inserted.
TAPE END
• When the tape end is detected, or when a key (FF, PLAY, etc.) which drives the tape forward is pressed in a mode that allows
transition to forward driving during the detection process.
CHECK THE CASSETTE [REC MODE]
• When the Audio Dubbing or AV Insert button is pressed at a tape position recorded in LP, or when LP mode is detected during
Audio Dubbing.
CHECK THE CASSETTE [AUDIO MODE]
• When the Audio Dubbing button is pressed at a tape position with 16-bit or 4-channel simultaneous recording, or when 16-bit
mode or 4-channel simultaneous recording mode is detected during audio dubbing.
CHECK THE CASSETTE [BLANK]
• When a blank tape area is detected during Audio Dubbing.
CHECK THE CASSETTE
To Next Page
Loading...
