CAPINTEC, INC. CAPRAC
®
-t
March 2021 SAFETY 1-7
385 380 –390 TETRA 400
modulation
b)
18 Hz
1,8 0,3 27
450 430 – 470 GMRS 460, FRS 460
c)
± 5 kHz
deviation
2 0,3 28
704 – 787 LTE Band 13, 17
modulation
b)
0,2 0,3 9
800 – 960
TETRA 800, iDEN 820,
CDMA 850,
modulation
b)
18 Hz
2 0,3 28
1 700 – 1
990
CDMA 1900;
GSM 1900;
DECT;
LTE Band 1, 3, 4, 25;
Pulse
modulation
b)
217 Hz
2 0,3 28
1 970
2 450
2 400 – 2
570
WLAN,
802.11 b/g/n, RFID
2450,
Pulse
modulation
b)
217 Hz
2 0,3 28
5 100 – 5
800
WLAN 802.11
a/n
modulation
b)
0,2 0,3 9
NOTE If necessary to achieve the IMMUNITY TEST LEVEL, the distance between the transmitting antenna and
the ME EQUIPMENT or ME SYSTEM may be reduced to 1 m. The 1 m test distance is permitted by IEC 61000-
a)
For some services, only the uplink frequencies are included.
b)
The carrier shall be modulated using a 50 % duty cycle square wave signal.
c)
As an alternative to FM modulation, 50 % pulse modulation at 18 Hz may be used because while it does not
represent actual modulation, it would be worst case.
GENERAL SAFETY TIPS
• Unplug the equipment before cleaning it. Use only a damp cloth; do not use solvents
or aerosol cleaners.
• To protect the equipment from overheating, do not use the equipment directly in front
of a radiator or heat register.
• Do not use the equipment near water, or spill liquids of any kind into the equipment.
• Be sure that your power source matches the rating listed on the CAPRAC
®
-t.
• The CAPRAC
®
-t power cord has a grounded, 3-prong plug as a safety feature, and it
will only fit into a grounded outlet. Do not use an adapter to defeat the grounding.
To Next Page
Loading...
Need help?
General