CAPINTEC, INC. CAPRAC
®
-t
April 2021 WIPE MEASUREMENT PROCEDURES 10-9
Measuring Wipes
When all the desired locations are on the Measurement List, touch the MEASURE LIST
button. Figure 10-7 Measure Wipe Start Screen will appear for the first selected location.
Figure 10-7 Measure Wipe Start Screen
The current Wipe Location name to be measured is displayed at the top of the screen along
with the total number of Wipe Locations selected.
If it is not desirable to measure this location, touch the SKIP WIPE button. The next Wipe
Location name in the list will appear at the top of the screen.
If it is desirable to cancel all subsequent wipe measurements, touch the SKIP ALL WIPES
button. Figure 10-2 Measurements Screen will appear.
Count Time
The counting time for the selected Wipe Location will be displayed. To change the
count time for this measurement only, touch the COUNT TIME button. The Numeric
Keypad screen will appear. Input the desired counting time (in seconds) by touching
the appropriate numbers on the keypad. Touch the ACCEPT button to accept the
entered time. Touch the CANCEL button to abort any changes.
Note: The minimum count time that can be input is 2 seconds. The maximum count
time that can be input is 30,000 seconds.
To Next Page
Loading...
Need help?
General