CAPINTEC, INC. CAPRAC
®
-t
10-8 WIPE MEASUREMENT PROCEDURES April 2021
Selecting Wipe Locations
A listing of all the Wipe Locations that have been setup will appear on the left half of the
screen in the Locations List.
The listing is in the order that the Locations were created. The length of the list will vary
depending on how many Locations have been setup. If there are more than 10 Locations, the
number of pages (or screens) will be shown in the upper right corner of the Locations
column indicating the length of the list. To scroll through the list, touch the DOWN ARROW
(▼) button below the Locations List. The next group of 10 Locations will be displayed and
an UP ARROW (▲) button will appear allowing the user to scroll up in the list.
Wipes are measured by first selecting the desired Wipe Location(s) from the Locations List,
moving them to the Measurement List on the right half of the screen and then touching the
MEASURE LIST button.
To measure all of the Wipe Locations in the order that they are listed in the Locations List,
touch the RIGHT DOUBLE ARROW button. This will move all of the Wipe Locations from the
Locations List to the Measurement List in the order that that are displayed in the
Locations List.
To move one Wipe Location to the Measurement List, touch the Location name to highlight
it. Then touch the RIGHT SINGLE ARROW button to move the location to the Measurement
List. To measure more than one Wipe Location in a specific order, move the Location names
to the Measurement List in the order that that are to be measured.
To move one Wipe Location from the Measurement List back to the Locations List, touch
the Location name to highlight it and then touch the LEFT SINGLE ARROW button.
To return all the locations to the Locations list, touch the LEFT DOUBLE ARROW button.
Wipes are measured in the order that they appear in the Measurement List.
To Next Page
Loading...
Need help?
General