CAPINTEC, INC. CAPRAC
®
-t
13-14 CLEANING AND MAINTENANCE April 2021
• Run the Diagnostic Test and make sure that the system expects to have a printer.
If not, Make sure that the Printer Menu Setup is correct. Reference CHAPTER 5:
SYSTEM INITIALIZATION, SECTION: PRINTING.
RELATED PRODUCTS
The following products are available from Capintec. Call Capintec’s only Authorized Service
Center at (800) ASK-4CRC for answers to your questions or to place an order.
• Rod Source: Cs137 (0.5 µCi) ...................................................... 0975-137R
• Rod Source: Eu152 (0.5 µCi) ...................................................... 0970-152R
• Well Counter Well Inserts (Liners) (pack of 100) .......................... 5420-0087
• ½” Auxiliary Shield ....................................................................... 5420-2072
• PET (1.5”) Auxiliary Shield ........................................................... 5420-2141
• Okidata 320 Ticket and Report Printer ......................................... 5110-1150
• Epson LX-300+II Ticket and Report Printer .................................. 5110-0126
• Epson Ticket Printer .................................................................... 5430-0100
• Epson Roll Printer ........................................................................ 5430-0058
• HP Inkjet Printer .......................................................................... 5430-0146
• Printer Ribbons ................................................................................ CALL
• Inkjet Cartridges .............................................................................. CALL
• Multi-part Tickets, Paper, etc. .......................................................... CALL
• Fuse: T 2 Amp. 250 Volts. (Readout Unit) 2 Req. ...................... 2110-0083
• 3V Lithium Coin Battery (CR2032) ............................................... 0500-0039
• Additional copies of Owner’s Manual ........................................... 9250-0140
Note: Circuit diagrams, component parts lists, descriptions and calibration instructions are
available to appropriately qualified personnel.
To Next Page