CAPINTEC, INC. CAPRAC
®
-t
April 2021 WELL COUNTER INITIALIZATION 6-43
When adding a Wipe Location, the default values for the selected Wipe Type will displayed.
These values may be used or may be customized for each location.
Note: When performing a Wipe Test, if no Wipe Locations have been setup, the message
“Wipe Error Unable to find any wipe locations Please setup a wipe location” will
appear.
From Figure 6-28 Well Wipes Setup Screen, touch the SETUP LOCATION button. Figure
6-34 Setup Wipe Locations Screen will appear.
Figure 6-34 Setup Wipe Locations Screen
To exit Figure 6-34 Setup Wipe Locations Screen,
• touch the BACK button – Figure 6-28 Well Wipes Setup Screen will appear or
• touch the HOME button – Figure 6-1 Main Screen will appear.
Adding a Location
To add a location, touch the ADD LOCATION button. Figure 6-35 Add New Wipe
Location Screen will appear.
To Next Page
Loading...