CAPINTEC, INC. CAPRAC
®
-t
5-10 SYSTEM INITIALIZATION April 2021
Okidata Menu Set-Up
If an Okidata Microline 320 printer was ordered with the CAPRAC
®
-t system, the Okidata
printer should be set up to function properly when received.
Should you experience printer difficulties, such as not printing, improper print spacing,
printing the wrong characters, etc., make sure that the printer Setup is exactly as indicated in
Figure 5-8 Listing of the Turbo OKIDATA 320 Printer Setup Data. If any differences are
found, they must be corrected.
The buttons referred to are all located on the front panel of the printer. The Paper Lever is on
the right side of the top surface of the printer near the paper roller.
To print and correct the Setup:
1. Make sure that the form paper is properly loaded in the printer.
2. Press the SEL button (to take printer off-line).
3. Press SHIFT + MENU (SEL) to enter the Setup Menu.
4. Press the PRINT button and the entire Setup listing will print.
5. If there are no differences between what just printed and Figure 5-8 Listing of the
Turbo OKIDATA 320 Printer Setup Data go to step 10.
6. Press the GROUP button. The first line of the first group of lines of the Setup will
print.
7. If all lines in the group just printed match the corresponding lines in Figure 5-8 Listing
of the Turbo OKIDATA 320 Printer Setup Data, repeat step 6 for the next group.
8. If any line in the group just printed does not match the corresponding line in Figure
5-8 Listing of the Turbo OKIDATA 320 Printer Setup Data, it must be corrected. For
example, to change the Baud Rate to 4800:
a. Press the GROUP button until Serial I/F is printed.
b. Press the ITEM button until Baud Rate is printed.
c. Press the SET button until 4800 BPS is printed.
9. If any differences remain, return to step 6 for the next group.
10. Press the SHIFT + MENU (SEL) buttons to return to SEL (on-line).
Note: The Setup printout shown in Figure 5-8 Listing of the Turbo OKIDATA 320 Printer
Setup Data is for example only. Your printer Setup may differ slightly from that shown.
Verify that the settings, which are the same between your Setup and that shown,
concur.
To Next Page
Loading...
Need help?
General