Ceragon FA4800 - Default FA4800 Settings; Table 4-4 Defaults

Default FA4800 Settings Chapter 4
FA4800 User Manual Release 1.9.40 4-11
Default FA4800 Settings
The default settings of the FA4800 configuration parameters are listed in the second column
of Table 4-4 below. The third column shows the values we use in this manual for illustrative
purposes.
Table 4-4: Default Settings
Parameter Default Value Illustrative Value
Factory default band Product dependent 5.780GHz
ODU IP Address 10.0.0.120 192.168.2.101 and 102
Subnet Mask 255.0.0.0 255.255.255.0
Trap destination 0.0.0.0 0.0.0.0
FibeAir2000 Manager log-on
passwords
Observer admin
Operator admin
Installer wireless
Link ID Link EBG_20561334
Link Name Name TPSF_BTT
Site 1 Site A
Site 2 Site B
Location (per site) Location A B
Name (per site) Name Here There
Contact (per site) Person John Mary
Link Password wireless-bridge
Rate Adaptive
Ethernet Configuration Auto Detect
Radio Link Failure Actions No action
Bridge or Hub mode Hub Mode, Aging time = 300 sec
Community values
Read-write – netman
Read-only – public