112
Cisco Dual LTE-Single GPS Multi-band Antenna Installation Guide (4G-LTE-ANTM-O-3-B)
Figure 11 Bottom View of the Antenna
6. Position the antenna onto the mounting surface and tighten the nut hand-tight, as shown in Figure 12. Tighten it further
using a wrench until the antenna is fully seated. Visually inspect the outer rubber antenna gasket to ensure that it has been
compressed and sealed tightly against the mounting surface and radome.
Figure 12 Tighten the Nut after the Antenna is fully seated
Deployment Scenarios
Figure 13 shows the deployment of the 4G-LTE-ANTM-O-3-B antenna on an ATM with a single router.
Note: All the three antenna cables are SubMiniature version A (SMA-male) connectors, but the MAIN and the Diversity (DIV) of
the router has the Threaded Neill–Concelman (TNC-female) connectors, and the GPS has an SMA-female connector. In this
case, an SMA-female to TNC-male adapter needs to be used to connect the SMA-male connectors to the MAIN and DIV of the
router because they cannot be connected to the SMA-male connectors directly.
1 Product ID and Serialization Label 2 MPN and Torque Label
3 Liner
4G-LTE-ANTM-O-3-B
INSTALLATION
TORQUE 4.5Nm
4G LTE 3 in 1 outdoor Black
antenna 700MHZ
www.cisco.com/go/4g
SN: 14300881
RoHs
Complaint
MPN: 07-01329-01
Made in: CN
10
1
2
3
372915
To Next Page
Loading...
