86
Cisco Systems, Inc. www.cisco.com
Cisco 4G/3G Omnidirectional Dipole
Antenna (4G-LTE-ANTM-D)
This document outlines the specifications, describes the Cisco 4G/3G Omnidirectional Dipole Antenna (4G-LTE-ANTM-D), and
contains the following sections:
Overview, page 86
Specifications, page 88
System Requirements, page 94
Installation Notes, page 94
Safety Instructions, page 95
Overview
The 4G-LTE-ANTM-D omnidirectional dipole antenna is designed for indoor use with Cisco 4G and Cisco 3G wireless Integrated
Services Routers Generation 2 (ISRs G2) and Enhanced High-Speed WAN Interface Cards (EHWICs).
The 4G-LTE-ANTM-D antenna is marked with a green band and the product ID (PID) to indicate that it supports 4G Long Term
Evolution (LTE) networks. It has the following hardware features:
Articulating Joint—It can be rotated 360 degrees and is capable of maneuvering into three stop positions: 0 degrees, 45
degrees, and 90 degrees.
Male threaded Neill-Concelman (TNC) Connector—It lets you directly mount the antenna to any Cisco 4G and Cisco 3G
wireless Integrated Services Router (ISR) EHWIC with a TNC connector (Figure 1). The threads on the connector must
comply with the ANSI 7/16-28 UNEF 2B thread specification.
To Next Page
Loading...
