Cisco AIR-ANT2544V4M-R - Installing the Antenna.; Mounting on a Pole

120
Cisco Aironet 2.4 GHz 13-dBi Directional Antenna (AIR-ANT2413P2M-N)
 Four 1/4-in. 20x3/4 carriage bolts
 Six 1/4-in. 20 hex nuts
 Six 1/4-in. 20 spring lock washers
 Six 1/4-in. 20 flat washers
 Two pipe clamps
To attach the mount to the antenna and secure it to the pole, you need the following tools and equipment, which are not
provided.
 7/16-in wrench
 5/16-in nut driver or flat head screwdriver for pipe clamps
The following sections contain typical procedures for installing the antenna on a pole. Your installation may vary. Before you
begin, you may want to refer to Figure 1.
Mounting on a Pole
Follow these steps to mount your antenna on a pole.
1. Remove antenna and mount kit from packaging.
2. Attach antenna mount bracket to the back of the antenna as shown applying a maximum nut-tightening torque of 55 in-lbf
(6.2 Nm).