Cisco AIR-ANT2544V4M-R Guide

184
Cisco Aironet Dual-Band MIMO Wall-Mounted Omnidirectional Antenna (AIR-ANT2544V4M-R)
Figure 6 Mounting on a Ceiling
Mounting on a Mast
The antenna can be mounted on a mast rather than on a wall using two 1/2 inch-wide hose clamps (not provided).
To mount the antenna on a mast, follow these steps:
1. Follow Steps 1 and Step 2 from the Mounting on a Vertical Surface.
2. Position the antenna, mounting bracket, and hose clamps on the mast.
3. Tighten the hose clamps until the antenna is secure on the mast.
Once the antenna is secured on the mast, you can adjust the azimuth and elevation.
4. To adjust the azimuth and elevation, loosen the bolt that attaches the antenna bracket to the mounting bracket (Figure 5).
Azimuth can be adjusted ±90 degrees. Elevation can be adjusted +15 degrees and -35 degrees.

Cisco AIR-ANT2544V4M-R Specifications

General

Brand	Cisco
Model	AIR-ANT2544V4M-R
Category	Antenna
Language	English