531
Outdoor Panel Antenna for WiMAX 1.8, 2.5, and 3.8 GHz
3. Attach the elevation adjustable bracket to the mount bracket using two sets of carriage bolts, washers, lock washers, and
hex nuts. Position the bolts so the carriage bolt square holes are positioned on the inside. Do not tighten fully. Allow the
bracket to move freely.
4. Position the azimuth adjustable (pipe) bracket to the pipe with the flanges away from the pipe. Secure each bracket to the
pipe first by routing the band clamps around the pipe, then through the two holes. Tighten to a maximum torque rating.
1 1/4”-20 hex nut 2 1/4”20 spring lock washer
3 1/4”-20 flat washer 4 Antenna mount bracket
1 1/4”-20 hex nut 2 1/4”-20 spring lock washer
3 1/4”-20 flat washer 4 Elevation adjustable bracket
5 Antenna-mount bracket 6 1/4”-20x3/4 carriage bolt
300676
1
2
3
4
300677
1
2
3
5
6
4
To Next Page
Loading...
