Cisco ASR 9000 Series

Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3 bridge group bridge-group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group csco
RP/0/RSP0/CPU0:router(config-l2vpn-bg)#
Creates a bridge group that can contain bridge domains, and then assigns network interfaces to the bridge domain.
Step 4 bridge-domain domain-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bd1
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)#
Establishes a bridge domain for R-APS channels, and enters L2VPN bridge group bridge domain configuration mode.
Step 5 interface type port0-interface-path-id.subinterface
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# interface GigabitEthernet 0/0/0/0.1
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-ac)#
Enters interface configuration mode and adds an interface to a bridge domain that allows packets to be forwarded and
received from other interfaces that are part of the same bridge domain.
Step 6 interface type port1-interface-path-id.subinterface
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# interface GigabitEthernet 0/0/0/1.1
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-ac)#
Enters interface configuration mode and adds an interface to a bridge domain that allows packets to be forwarded and
received from other interfaces that are part of the same bridge domain.
Step 7 bridge-domain domain-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bd2
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)#
Establishes a bridge domain for data traffic, and enters L2VPN bridge group bridge domain configuration mode.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
281
Implementing Multipoint Layer 2 Services
Configuring an ERP Instance