Cisco ASR 9000 Series - Page 454

Enters the MSTP configuration submode.
Step 3 bringup delay for interval { minutes | seconds }
Example:
RP/0/RSP0/CPU0:router(config-mstp)#bringup delay for 10 minutes
Configures the time interval to delay bringup for.
Step 4 flush containment disable
Example:
RP/0/RSP0/CPU0:router(config-mstp)#flush containment disable
Disable flush containment.
This command performs MAC flush on all instances regardless of the their state.
Step 5 name name
Example:
RP/0/RSP0/CPU0:router(config-mstp)# name m1
Sets the name of the MSTP region.
The default value is the MAC address of the switch, formatted as a text string by means of the hexadecimal representation
specified in IEEE Std 802.
Step 6 revision revision -number
Example:
RP/0/RSP0/CPU0:router(config-mstp)# revision 10
Sets the revision level of the MSTP region.
Allowed values are from 0 through 65535.
Step 7 forward-delay seconds
Example:
RP/0/RSP0/CPU0:router(config-mstp)# forward-delay 20
Sets the forward-delay parameter for the bridge.
Allowed values for bridge forward-delay time in seconds are from 4 through 30.
Step 8 maximum { age seconds | hops hops }
Example:
RP/0/RSP0/CPU0:router(config-mstp)# max age 40
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
428
Implementing Multiple Spanning Tree Protocol
Configuring MSTP parameters