Mirroring Logical Device: disk0:
Mirroring Logical Device2: disk1:
Physical Device State Flags
--------------------------------------------------------
disk0: Available Enabled
disk1: Available Enabled
compactflash: Available
(null) Available
disk0a: Available
disk1a: Available
compactflasha: Not Present
harddisk: Available
Mirroring Rommon Variable
BOOT_DEV_SEQ_CONF = disk0:;disk1:
BOOT_DEV_SEQ_OPER = disk0:;disk1:
MIRROR_ENABLE = Y
mirror verify Command Output: Example
RP/0/RSP0/CPU0:router# mirror verify
Mirror Verify Information for 0/0/CPU0.
========================================================
Primary device and secondary device are fully synchronized.
Additional References
The following sections provide references related to disk mirroring configuration.
Related Documents
Document TitleRelated Topic
Cisco ASR 9000 Series Aggregation Services Router
Getting Started Guide
Initial system bootup and configuration information
for a router using the Cisco IOS XR software
Configuring AAA Services on the Cisco ASR 9000
Series Router module of Cisco ASR 9000 Series
Aggregation Services Router System Security
Configuration Guide
Information about user groups and task IDs
Cisco ASR 9000 Series Aggregation Services Router
Commands Master List
Cisco IOS XR command master list
Boot Commands on the Cisco ASR 9000 Series
Router module of Cisco ASR 9000 Series
Aggregation Services Router System Management
Command Reference
Cisco IOS XR boot commands
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
83
Configuring Disk Mirroring
Additional References
To Next Page
Loading...
Need help?
General
