Cisco ASR 9000 Series User Manual

0/RSP0/CPU0 A9K-RSP-4G(Active) IOS XR RUN PWR,NSHUT,MON
0/1/CPU0 A9K-40GE-B IOS XR RUN PWR,NSHUT,MON
0/4/CPU0 A9K-8T/4-B IOS XR RUN PWR,NSHUT,MON
0/6/CPU0 A9K-4T-B IOS XR RUN PWR,NSHUT,MON
The node-id appears in the rack/slot/module notation, and the node-id components are as follows:
• rack —In a single-shelf system the rack number is always “0.”
• slot —Number of the physical slot in which the card is installed.
• module —Subslot number of a system hardware component.
Table 15: Node ID Components, on page 108 summarizes the node-id argument for each type of card.
Displaying Router Environment Information
The show environment command displays hardware information for the system, including fan speeds, LED
indications, power supply voltage and current information, and temperatures.
The syntax for the show environment command is:
show environment [options]
You can use the show environment command options to limit the detail in the command display. To view
the command options, enter the show environment ? command. The following example shows the full
environment status report:
RP/0/RSP0/CPU0:router(admin)# show environment
Mon Jun 29 04:32:07.587 PST
Temperature Information
---------------------------------------------
R/S/I Modules Inlet Hotspot
Temperature Temperature
(deg C) (deg C)
0/1/*
host 31.5 39.5
0/RSP0/*
host 26.6 36.6
0/4/*
host 29.8 38.8
0/6/*
host 32.7 42.0
0/FT0/*
host 27.2 28.2
0/FT1/*
host 27.4 30.2
Voltage Information
---------------------------------------------
R/S/I Modules Sensor (mV) Margin
0/1/*
host IBV 10647 n/a
host 5.0V 4929 n/a
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
109
Managing the Router Hardware
Displaying Router Environment Information

Cisco ASR 9000 Series Specifications

General

Brand	Cisco
Model	ASR 9000 Series
Category	Network Router
Language	English