Cisco ASR 9000 Series User Manual

PurposeCommand or Action
Displays the running configuration.
show run interface value
Example:
RP/0/RSP0/CPU0:router# show run interface
Step 13
tengige0/1/0/5
Fri Aug 3 19:57:14.184 UTC
interface TenGigE0/1/0/5
ptp
profile tp64
transport ipv4
port state slave-only
master ipv4 1.7.1.2
!
announce timeout 2
!
ipv4 address 1.7.1.1 255.255.255.0
transceiver permit pid all
!
Configuring the Clock Interface for a PTP Master
Use these steps to configure a clock interface for the PTP master:
SUMMARY STEPS
1.
configure
2.
clock-interface sync value location node
3.
port-parameters dti
4.
frequency synchronization
5.
selection input
6.
priority number
7.
wait-to-restore number
8.
ssm disable
9.
quality receive exact itu-t option number generation number PRS
10.
Use one of these commands:
•
end
•
commit
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
243
Configuring PTP
Configuring the Clock Interface for a PTP Master

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model