Cisco ASR 9000 Series User Manual

PurposeCommand or Action
Sets the timeout for PTP announce messages.
announce timeout timeout
Example:
RP/0/RSP0/CPU0:router(config-if-ptp)# announce
timeout 2
Step 6
Returns to configuration mode for the interface.exit
Example:
RP/0/RSP0/CPU0:router(config-if-ptp)# exit
Step 7
Configures the gateway for the interface.
ipv4 address address mask
Example:
RP/0/RSP0/CPU0:router(config-if)# ipv4 address
1.7.1.2 255.255.255.0
Step 8
Configures the transceiver for the interface.transceiver permit pid all
Example:
RP/0/RSP0/CPU0:router(config-if)# transceiver
permit pid all
Step 9
commit
Step 10
Shows the running configuration.
show run interface value
Example:
RP/0/RSP0/CPU0:router# show run interface
Step 11
Te0/1/0/5
Fri Aug 3 13:57:44.366 PST
interface TenGigE0/5/1/0
ptp
profile tp64
transport ipv4
announce timeout 2
!
ipv4 address 1.7.1.2 255.255.255.0
transceiver permit pid all
!
Configuring GPS Settings for the Grand Master Clock
Use these steps to configure GPS settings for PTP.
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
247
Configuring PTP
Configuring GPS Settings for the Grand Master Clock

Cisco ASR 9000 Series Specifications

General

Brand	Cisco
Model	ASR 9000 Series
Category	Network Router
Language	English