PurposeCommand or Action
A9K-24X10G-AIP-TR location 0/0/CPU0
Associates the new license on the slot with the new
line card.
Remove the old line cards and install the new ones.
Step 5
You need to wait for the new line cards to
boot.
Note
Verifies the status of the licenses.show license
Step 6
Example:
RP/0/RSP0/CPU0:router# show license
Old licenses remaining on the router are not
a problem.
Note
Thu May 31 08:52:39.876 PST
FeatureID: A9K-24X10G-AIP-TR (Slot based, Permanent)
Total licenses 1
Available for use 0
Allocated to location 0
Active 1
Store name Permanent
Store index 3
Pool: Owner
Total licenses in pool: 1
Status: Available 0 Operational: 1
Locations with licenses: (Active/Allocated) [SDR]
0/0/CPU0 (1/0) [Owner]
Troubleshooting License Issues after a Software Upgrade
In the instance that you were running Cisco IOS XR Release 3.9.0 and had the optic feature enabled on a
interface and the A9K-ADV-OPTIC-LIC license was active on a particular slot, when you upgrade to Cisco
IOS XR Release 4.0.0, the A9K-ADV-OPTIC-LIC license is still active, but you may get the following
warning message:
RP/0/RSP0/CPU0:Jul 27 14:22:22.594 : licmgr[236]:
%LICENSE-LICMGR-4-PACKAGE_LOCATION_LICENSE_INVALID :
Feature associated to package A9K-ADV-OPTIC-LIC configured
on node 0/4/CPU0 without a valid license
To solve this issue, configure the license command in administration EXEC mode. This binds the
A9K-ADV-OPTIC-LIC license to the slot on which you are using the license. For example:
RP/0/RSP0/CPU0:router(admin-config)# license A9K-ADV-OPTIC-LIC location 0/4/CPU0
RP/0/RSP0/CPU0:router(admin-config)# commit
Additional References
The following sections provide references related to Cisco IOS XR software entitlement.
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
95
Software Entitlement
Troubleshooting License Issues after a Software Upgrade
To Next Page
Loading...
Need help?
General
