Cisco ASR 9000 Series User Manual

PurposeCommand or Action
•
When you issue the end command, the system prompts you to
commit changes:
Uncommitted changes found, commit them
before exiting(yes/no/cancel)? [cancel]:
•
end
•
commit
Example:
RP/0/RSP0/CPU0:router(config-freqsync)#
end
◦
Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and returns
the router to EXEC mode.
or
RP/0/RSP0/CPU0:router(config-freqsync)#
commit
◦
Entering no exits the configuration session and returns the
router to EXEC mode without committing the configuration
changes.
◦
Entering cancel leaves the router in the current configuration
session without exiting or committing the configuration
changes.
•
Use the commit command to save the configuration changes to
the running configuration file, and remain within the configuration
session.
Configuring Global Profile Settings for PTP
Use these steps to configure a global configuration profile for a PTP interface. This profile can then be assigned
to any interface as required. You can override this configuration for any particular interface using configuration
commands in interface PTP configuration mode. See Configuring a PTP Slave Interface, on page 241 or
Configuring a PTP Master Interface, on page 245 for more information.
SUMMARY STEPS
1.
configure
2.
ptp
3.
profile name
4.
sync frequency rate
5.
delay-request frequency rate
6.
Use one of these commands:
•
end
•
commit
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
239
Configuring PTP
Configuring Global Profile Settings for PTP

Cisco ASR 9000 Series Specifications

General

Brand	Cisco
Model	ASR 9000 Series
Category	Network Router
Language	English