Cisco ASR 9000 Series

CHAPTER 18
Implementing Physical and Virtual Terminals
Line templates define standard attribute settings for incoming and outgoing transport over physical and
virtual terminal lines (vtys). Vty pools are used to apply template settings to ranges of vtys.
Before creating or modifying the vty pools, enable the telnet server using the telnet server command in
Global Configuration mode. See Cisco ASR 9000 Series Aggregation Services Router IP Addresses and
Services Configuration Guide and Cisco ASR 9000 Series Aggregation Services Router IP Addresses and
Services Command Reference for more information.
Note
This module describes the new and revised tasks you need to implement physical and virtual terminals on
your Cisco IOS XR network.
For more information about physical and virtual terminals on the Cisco IOS XR software and complete
descriptions of the terminal services commands listed in this module, see Related Documents, on page 352.
To locate documentation for other commands that might appear in the course of running a configuration
task, search online in Cisco ASR 9000 Series Aggregation Services Router Commands Master List.
Table 35: Feature History for Implementing Physical and Virtual Templates on Cisco IOS XR Software
ModificationRelease
This feature was introduced.Release 3.7.2
This module contains the following topics:
•
Prerequisites for Implementing Physical and Virtual Terminals, page 344
•
Information About Implementing Physical and Virtual Terminals, page 344
•
How to Implement Physical and Virtual Terminals on Cisco IOS XR Software, page 346
•
Craft Panel Interface, page 350
•
Configuration Examples for Implementing Physical and Virtual Terminals, page 350
•
Additional References, page 352
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
343