Cisco ASR 9000 Series

PurposeCommand or Action
◦
Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and
returns the router to EXEC mode.
or
RP/0/RSP0/CPU0:router(config-ntp)# commit
◦
Entering no exits the configuration session and returns
the router to EXEC mode without committing the
configuration changes.
◦
Entering cancel leaves the router in the current
configuration session without exiting or committing the
configuration changes.
•
Use the commit command to save the configuration changes
to the running configuration file and remain within the
configuration session.
Configuring the Source IP Address for NTP Packets
By default, the source IP address of an NTP packet sent by the router is the address of the interface through
which the NTP packet is sent. Use this procedure to set a different source address.
No specific command enables NTP; the first NTP configuration command that you issue enables NTP.Note
SUMMARY STEPS
1.
configure
2.
ntp
3.
source type interface-path-id
4.
Use one of the following commands:
•
end
•
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
219
Implementing NTP
Configuring the Source IP Address for NTP Packets