Cisco ASR 9000 Series User Manual

PurposeCommand or Action
If the retry command is used, you should configure a retain
interval larger than 0. The interval between retries is the retain
interval divided by the retry number. For example, if retain 10
and retry 2 are configured, two retries are attempted once every
5 minutes. Therefore, if retain 0 is configured, no retries are
attempted.
Note
Begins the bulk statistics data collection and transfer process for this
configuration.
enable
Example:
RP/0/RSP0/CPU0:router(config-bulk-tr)#
enable
Step 11
•
For successful execution of this action, at least one schema with
non-zero number of objects must be configured.
•
Periodic collection and file transfer begins only if this command
is configured. Conversely, the no enable command stops the
collection process. A subsequent enable starts the operations again.
•
Each time the collection process is started using the enable
command, data is collected into a new bulk statistics file. When
the no enable command is used, the transfer process for any
collected data immediately begins (in other words, the existing
bulk statistics file is transferred to the specified management
station).
commit
Step 12
What to Do Next
If the maximum buffer size for a bulk statistics file is reached before the transfer interval time expires,
the transfer operation is still initiated, but any bulk statistics data received after the file was full, and before
it was transferred, are deleted. To correct this behavior, you can decrease the polling frequency, or increase
the size of the bulk statistics buffer.
If retain 0 is configured, no retries are attempted. This is because the interval between retries is the retain
value divided by the retry value. For example, if retain 10 and retry 2 are configured, retries are attempted
once every 5 minutes. Therefore, if you configure the retry command, you should also configure an
appropriate value for the retain command.
Note
Monitoring Periodic MIB Data Collection and Transfer
SUMMARY STEPS
1.
show snmp mib bulkstat transfer transfer-name
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
391
Configuring Periodic MIB Data Collection and Transfer
Monitoring Periodic MIB Data Collection and Transfer

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model