Cisco ASR 9000 Series

PurposeCommand or Action
(Optional)
Establishes the message queue length for each
notification.
snmp-server queue-length length
Example:
RP/0/RSP0/CPU0:router(config)# snmp-server
queue-length 20
Step 3
(Optional)
Defines how often to resend notifications on the
retransmission queue.
snmp-server trap-timeout seconds
Example:
RP/0/RSP0/CPU0:router(config)# snmp-server
trap-timeout 20
Step 4
commit
Step 5
Setting IP Precedence and DSCP Values
This task describes how to configure IP Precedence or IP DSCP for SNMP traffic.
Before You Begin
SNMP must be configured.
SUMMARY STEPS
1.
configure
2.
Use one of the following commands:
•
snmp-server ipv4 precedence value
•
snmp-server ipv4 dscp value
3.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Configures an IP precedence or IP DSCP
value for SNMP traffic.
Use one of the following commands:
Step 2
•
snmp-server ipv4 precedence value
•
snmp-server ipv4 dscp value
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
371
Implementing SNMP
Setting IP Precedence and DSCP Values