Cisco ASR 9000 Series User Manual

Proceed with switchover 0/RSP0/CPU0 -> 0/RSP1/CPU0? [confirm]
Initiating switch-over.
RP/0/RSP0/CPU0:router#
<Your 'TELNET' connection has terminated>
In the preceding example, the Telnet connection is lost when the previously active RP resets. To continue
management of the router, you must connect to the newly activated RP as shown in the following example:
User Access Verification
Username: xxxxx
Password: xxxxx
Last switch-over Sat Apr 15 12:26:47 2009: 1 minute ago
RP/0/RSP1/CPU0:router#
If the standby RSP is not in “ready” state, the switchover operation is not allowed. In the following example,
partial output for a failed redundancy switchover attempt is shown:
RP/0/RSP0/CPU0:router# show redundancy
Redundancy information for node 0/RP1/CPU0:
==========================================
Node 0/RSP0/CPU0 is in ACTIVE role
Partner node (0/RSP1/CPU0) is in UNKNOWN role
Reload and boot info
----------------------
RP reloaded Wed Mar 29 17:22:08 2009: 2 weeks, 2 days, 19 hours, 14 minutes ago
Active node booted Sat Apr 15 12:27:58 2009: 8 minutes ago
Last switch-over Sat Apr 15 12:35:42 2009: 1 minute ago
There have been 4 switch-overs since reload
RP/0/RSP0/CPU0:router# redundancy switchover
Switchover disallowed: Standby node is not ready.
Communicating with a Standby RP
The active RSP automatically synchronizes all system software, settings, and configurations with the standby
RSP.
If you connect to the standby RSP through the console port, you can view the status messages for the standby
RSP. The standby RSP does not display a CLI prompt, so you cannot manage the standby card while it is in
standby mode.
If you connect to the standby RSP through the management Ethernet port, the prompt that appears is for the
active RSP, and you can manage the router the same as if you had connected through the management Ethernet
port on the active RSP.
Reloading, Shutting Down, or Power Cycling a Node
Use the commands described in this section to reload the Cisco IOS XR software on the active RSP or on any
specified node in the system. This section also describes the commands used to administratively shut down
a node and power a node on or off.
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
119
Managing the Router Hardware
Communicating with a Standby RP

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model