Cisco ASR 9000 Series User Manual

To specify a subinterface, prefix the expression with the characters \. (backslash period). For example, use
interface 'GigabitEthernet.*\..*' to configure all Gigabit Ethernet subinterfaces.
You can specify Layer 2 transport interfaces or point-to-point interfaces as shown in these examples:
group g-l2t
interface 'Gi.*\..*' l2transport
.
.
end-group
group g-ptp
interface 'Gi.*\..*' point-to-point
.
.
end-group
Regular Expressions for an OSPF Configuration
Exact router process names and OSPF areas cannot be used. You must use a regular expression to specify a
process name or group of OSPF areas. To specify that the OSFP area can be either a scalar value or an IP
address, use the regular expression ‘.*’, as in this example:
group g-ospf
router ospf '.*'
area '.*'
mtu-ignore enable
!
!
end-group
To specify that the OSPF area must be an IP address, use the expression '\.' as in this example:
group g-ospf-ipaddress
router ospf '.*\..*\..*\..*'
area '.*'
passive enable
!
!
end-group
To specify that the OSPF area must be a scalar value, use the expression '1.*', as in this example:
group g-ospf-match-number
router ospf '.*'
area '1.*'
passive enable
!
!
end-group
Regular Expressions for a BGP AS
Exact BGP AS values cannot be used in configuration groups. Use a regular expression to specify either AS
plain format, or AS dot format as in the format X.Y. To match AS plain format instances, use a simple regular
expression. To match AS dot format instances, use two regular expressions separated by a dot, as shown in
this example:
group g-bgp
router bgp '*'.'*'
address-family ipv4 unicast
!
!
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
137
Configuring Flexible Command Line Interface Configuration Groups
Regular Expressions in Configuration Groups

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model