SPA ROMMON spa rommon 2.12 0.0 0.140
----------------------------------------------------------------------------------------------
SPA-OC192POS-XFP SPA FPGA swv1.2 hwv2 spa fpga1 1.02 0.0 2.0
----------------------------------------------------------------------------------------------
SPA-2XOC48POS/RPR SPA FPGA swv1.0 spa fpga1 1.00 0.0 0.0
----------------------------------------------------------------------------------------------
SPA-8XOC3-POS SPA FPGA swv1.0 spa fpga1 1.00 0.0 0.5
----------------------------------------------------------------------------------------------
SPA-10X1GE-V2 SPA FPGA swv1.10 spa fpga1 1.10 0.0 0.0
----------------------------------------------------------------------------------------------
SPA-5X1GE-V2 SPA FPGA swv1.10 spa fpga1 1.10 0.0 0.0
----------------------------------------------------------------------------------------------
SPA-1X10GE-L-V2 SPA FPGA swv1.9 spa fpga1 1.09 0.0 0.0
----------------------------------------------------------------------------------------------
SPA-4XOC3-POS-V2 SPA FPGA swv1.0 spa fpga1 1.00 0.0 0.5
----------------------------------------------------------------------------------------------
SPA-1X10GE-WL-V2 SPA FPGA swv1.9 spa fpga1 1.09 0.0 0.0
----------------------------------------------------------------------------------------------
This table describes the significant fields shown in the display:
Table 23: show fpd package Field Descriptions
DescriptionField
Module part number.Card Type
Description of all FPD images available for the SPA.FPD Description
Hardware type. Possible types can be:
• spa—Shared port adapter
• lc—Line card
Type
FPD subtype. These values are used in the upgrade
hw-module fpd command to indicate a specific FPD image
type to upgrade.
Subtype
FPD software version recommended for the associated module
running the current Cisco IOS XR software.
SW Version
Minimum required FPD image software version to operate
the card. Version 0.0 indicates that a minimum required image
was not programmed into the card.
Min Req SW Vers
Minimum required hardware version for the associated FPD
image. A minimum hardware requirement of version 0.0
indicates that all hardware can support this FPD image
version.
Min Req HW Vers
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
173
Upgrading FPD
show fpd package Command Output: Example
To Next Page
Loading...
