EasyManuals Logo
Home>Cisco>Network Router>ASR 9000 Series

Cisco ASR 9000 Series User Manual

Cisco ASR 9000 Series
422 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #369 background imageLoading...
Page #369 background image
session-limit 10
disconnect-character 0x59
session-timeout 100
transport input telnet
transport output telnet
In this configuration example, the following terminal attributes are applied to the console line template:
The EXEC time out for terminal sessions is set to 0 minutes, 0 seconds. Setting the EXEC timeout to 0
minutes and 0 seconds disables the EXEC timeout function; thus, the EXEC session for the terminal
session will never time out.
The escape character is set to the 0x5a hexadecimal value (the 0x5a hexadecimal value translates into
the Z character).
The session limit for outgoing terminal sessions is set to 10 connections.
The disconnect character is set to 0x59 hexadecimal value (the 0x59 hexadecimal character translates
into the Y character).
The session time out for outgoing terminal sessions is set to 100 minutes (1 hour and 40 minutes).
The allowed transport protocol for incoming terminal sessions is Telnet.
The allowed transport protocol for outgoing terminal sessions is Telnet.
To verify that the terminal attributes for the console line template have been applied to the console, use the
show line command:
RP/0/RSP0/CPU0:router# show line console location 0/0/CPU0
Tty Speed Modem Uses Noise Overruns Acc I/O
* con0/0/CPU0 9600 - - - 0/0 -/-
Line con0_0_CPU0, Location "Unknown", Type "Unknown"
Length: 24 lines, Width: 80 columns
Baud rate (TX/RX) is 9600, 1 parity, 2 stopbits, 8 databits
Template: console
Config:
Allowed transports are telnet.
Modifying the Default Template: Example
This configuration example shows how to override the terminal settings for the default line template:
line default
exec-timeout 0 0
width 512
length 512
In this example, the following terminal attributes override the default line template default terminal attribute
settings:
The EXEC timeout for terminal sessions is set to 0 minutes and 0 seconds. Setting the EXEC timeout
to 0 minutes and 0 seconds disables the EXEC timeout function; thus, the EXEC session for the terminal
session will never time out (the default EXEC timeout for the default line template is 10 minutes).
The width of the terminal screen for the terminals referencing the default template is set to 512 characters
(the default width for the default line template is 80 characters).
The length, the number of lines that will display at one time on the terminal referencing the default
template, is set to 512 lines (the default length for the default line template is 24 lines).
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
351
Implementing Physical and Virtual Terminals
Configuration Examples for Implementing Physical and Virtual Terminals

Table of Contents

Other manuals for Cisco ASR 9000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 9000 Series and is the answer not in the manual?

Cisco ASR 9000 Series Specifications

General IconGeneral
BrandCisco
ModelASR 9000 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals