RSP Redundancy During RSP Reload 118
Manual Switchover 118
Communicating with a Standby RP 119
Reloading, Shutting Down, or Power Cycling a Node 119
Reloading the Active RSP 120
Flash Disk Recovery 122
Using Controller Commands to Manage Hardware Components 123
Formatting Hard Drives, Flash Drives, and Other Storage Devices 123
Removing and Replacing Cards 124
Removing Line Cards 124
Replacing a Line Card with the Same Media Type and Port Count 125
Replacing a Line Card with the Same Media Type and a Different Port Count 125
Replacing a Line Card or PLIM with a Different Media Type 126
Upgrading the CPU Controller Bits 126
Examples 126
Additional References 127
CHAPTER 8
Configuring Flexible Command Line Interface Configuration Groups 129
Information About Flexible CLI Configuration Groups 129
Flexible Configuration Restrictions 130
Configuring a Configuration Group 131
Simple Configuration Group: Example 133
Configuration Group Applied to Different Places: Example 133
Verifying the Configuration of Configuration Groups 133
Apply Groups Priority Inheritance 135
Regular Expressions in Configuration Groups 136
Configuration Examples Using Regular Expressions 138
Configuration Group with Regular Expression: Example 138
Configuration Group Inheritance with Regular Expressions: Example 140
Layer 2 Transport Configuration Group: Example 141
Configuration Group Precedence: Example 142
Changes to Configuration Group are Automatically Inherited: Example 142
Configuration Examples for Flexible CLI Configuration 143
Basic Flexible CLI Configuration: Example 143
Interface MTU Settings for Different Interface Types: Example 144
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
vii
Contents
To Next Page
Loading...
Need help?
General
