EasyManuals Logo

Cisco CRS Configuration Guide

Cisco CRS
430 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
Where DocumentedIntroduced/Changed in ReleaseDescriptionFeature
Implementing MPLS Traffic
Engineering chapter:
MPLS TE Auto-tunnel Mesh
One-hop, on page 213
Enabling Auto-onehop Tunnels
to Next-hop Neighbors, on
page 340
Release 5.1.2This feature was introduced.MPLS TE Auto-tunnel Primary
One-hop
Implementing MPLS Traffic
Engineering chapter:
Inter-area Traffic Engineering
with Dynamic ABR Discovery,
on page 213
Release 5.1.2This feature was introduced.Inter-area Traffic Engineering
with Dynamic ABR Discovery
Implementing GMPLS UNI
chapter:
GMPLS RSVP VRF Signaling,
on page 373
Release 5.1.3This feature was introduced.GMPLS RSVP VRF Signaling
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
3
New and Changed Feature Information in Cisco IOS XR Release 5.1.x
New and Changed Feature Information in Cisco IOS XR Release 5.1.x

Table of Contents

Other manuals for Cisco CRS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco CRS and is the answer not in the manual?

Cisco CRS Specifications

General IconGeneral
Operating SystemCisco IOS XR
Product TypeCore Router
Form FactorModular Chassis
DimensionsVaries by chassis type
WeightVaries by chassis type
ArchitectureDistributed
Switch FabricMulti-stage
Interface SupportEthernet, SONET/SDH, OTN
Interfaces/PortsVaries by line card
Port DensityVaries by line card
Routing ProtocolBGP, IS-IS, OSPF, MPLS
ManagementCLI, SNMP
Power SupplyRedundant, hot-swappable
CoolingRedundant, Hot-swappable Fan Trays
Supported ProtocolsIPv4, IPv6, MPLS
Management InterfacesEthernet, console
Security FeaturesACLs

Related product manuals