PurposeCommand or Action
Enables parameters for IGP routing over tunnel.autoroute announce
Example:
RP/0/RP0/CPU0:router(config-te-attribute-set)#
autoroute announce
Step 6
Enables fast-reroute bandwidth protection and node protection
for auto-mesh tunnels.
fast-reroute protect bandwidth node
Example:
RP/0/RP0/CPU0:router(config-te-attribute-set)#
fast-reroute
Step 7
Enables automatic bandwidth collection frequency, and controls
the manner in which the bandwidth for a tunnel collects output
rate information, but does not adjust the tunnel bandwidth.
auto-bw collect-bw-only
Example:
RP/0/RP0/CPU0:router(config-te-attribute-set)#
auto-bw collect-bw-only
Step 8
Sends out the log message when the tunnel LSP goes up or down
when the software is enabled.
logging events lsp-status {state |
insufficient-bandwidth | reoptimize | reroute }
Step 9
Example:
RP/0/RP0/CPU0:router(config-te-attribute-set)#
logging events lsp-status state
Sends out the log message when the tunnel LSP undergoes setup
or reoptimize failure due to bandwidth issues.
Sends out the log message for the LSP reoptimize change alarms.
Sends out the log message for the LSP reroute change alarms.
commit—Saves the configuration changes and remains within
the configuration session.
Use the commit or end command.
Step 10
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Related Topics
Auto-Tunnel Mesh, on page 206
Destination List (Prefix-List), on page 207
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
329
Implementing MPLS Traffic Engineering
Configuring Tunnel Attribute-Set Templates
To Next Page
Loading...
Need help?
General
